Actis Tri iso Sols Multi-foil Insulation for Under-floor Heating

Triso Sols uniformly reflects the heat generated by hot water under floor heating systems.

It eliminates thermal bridging at floor edges (because the insulation product can be turned up the walls at the perimeters.

Also, it reduces linear heat loss, as well as reducing impact noises.

The volume of living spaces to heat is reduced, and the surface area of insulation to install becomes smaller.

Ideal for renovation:

gain headroom (thickness = 7mm)

Applications

Hot-water underfloor heating systems

Can also be used below the screed on a standard floor

Technical characteristics

Uniformly reflects the heat from hot-water underfloor heating systems back up into the room.

Eliminates thermal bridging at floor perimeter

Quick and easy installation.

Additional benefit ... Grid marking facilitates the laying of heating pipes

Technical Performance

Dimensions

Thicknes = 7mm
1.58 meters x 12.66 meters = 20m2
Weight per roll = 12.5 kg

Composition

Numer of layers = 13 ... 6 reflecting layers
1 grid-squared polyethylene film, 6 foam layers, 4 internal reflective films, 2 metallic films with reinforcing mesh
Surface weight = 63g/m2

Mechanical properties

Breaking Strength ...
Warp = > 550 N - BS EN ISO 13934-1
Weft = > 300 N

Tear Strength ...
Warp = > 60N - BS EN ISO 13937-2
Weft = >25N

Properties

Due to the product's thinness (7 mm), there is no need to cut the base of doors and room heights can be preserved.

Quick and easy installation :

Flexible insulation product, which can be cut with scissors.

Integrated grid-squared polyethylene film.

Durable

Non irritant to the touch, hypoallergenic.

No protective equipment (overalls etc.) needed.

 

Installation

Preparation

Prepare the floor substrate to obtain a clean, dry and smooth surface.

 

Laying the first length of product

Unroll the insulation product on the floor substrate and turn the product 100 mm up the walls (to ensure insulation at the floor perimeter).

Laying the next lengths of product

Do not overlap the long edges, instead butt the long edges together.
The polyethylene film should be the only part of the insulation product to overlap.
Cover the joints with ISODHESIF or suitable aluminised tape.

Finishes

Install the underfloor heating system (heating circuit and screed finish) following the manufacturer's instructions.

 

Manufacturer

Actis Insulation Limited, Unit 1 Cornbrash Park - Bumpers Way,
Bumpers Farm Industrial Estate, Chippenham Wilts - SN14 6RA
Tel. 01249 462 888 - Fax. 01249 446 345 - Email: solutions@actis-isolation.com

Page last updated Tuesday, June 1, 2010